HpH 304cz Stripe
General Description
HpH 304cz Stripe pair, left and right side is available in Red or Blue.
We use only the best materials. Our high gloss premium film is rated for 7 years continuous outdoor use. It is the thinnest on the market at 2 mils. This is an air egress film. If a small bubble develops during installation it will go away in just a few days.
Installation
Step 1
Clean the surface. If applying on gelcoat clean with Wx Seal or similar. For plastic or glass use an all purpose cleaner or window cleaner. Do not apply when the temperature is less than 60° or over 90°.
Step 2
Make a Hinge. Apply a line of tape along the top of the decal. Half of the tape goes on the translucent paper and the other half will be stuck to the surface in Step 3.
Step 3
Place. Carefully line up and place your decal on the surface. It's easier on large decals to Skip step 2 and place two small pieces of tape on each upper corner then stick to the surface. This way if it's not lined up perfect you can easily remove it. Once satisfied with the position then take a long piece of tape along the top to serve as a hinge. NOTE: If you use a wet installation with a splay bottle, drop of soap and water DO NOT let the decal sit wet for more than 5 minutes. IF left too long the translucent paper will degrade.