Eos PNA Power and Data
General Description
Eos PNA power and data interface is a special unit that connects straight to User port on Eos device.
Features
• It has 5V power supply on USB connector for charging your PNA.It also converts TTL levels of serial communication to RS232 levels suitable for PNAs.• On one side there is a 5pin USB mini B connector. Use this to connect to your PNA. On other side there is 6–pin RJ11 cable. You should connect this to USER port on LX Eos.
• Note: Some PNAs (e.g. Vertica) are using 10 pin USB mini–B connectors. Use 5–pin to 10–pin extension cable which is usually supplied with the PNA device.
• USB mini B pinout:
Pin 1 = +5V
Pin 2 = RX
Pin 3 = TX
Pin 4 = +5V
Pin 5 = GND
Functions
• Variometer, TE compensation by TE probe or electronic way• Speed–to–fly function
• Final glide calculator based on GPS data!
• Simple navigation to TP and TSK
• High level IGC approved flight recorder
• Flarm radar screen (ADSB and Flarm Traffic)
• Thermal assistant screen
• System extensions: Second seat configuration, Remote control operation (LX Joy)
• Logbook
• Flight information with Barograph
• Multi pilot support
• Accurate wind calculation in straight flight and circling